Subject	Re: Make sure your idler pulleys are torqued down properly
Posted by	mkhoid on May 01, 2012 at 6:59 AM
	This message has been viewed 94 times.
In Reply To	Make sure your idler pulleys are torqued down properly (n/m) posted by AHos(Chicago) on April 30, 2012 at 01:13 PM
Message	adn correctly gapped. Should be ike .03-.04mm if i'm not mistaken.
Follow Ups	now its the TB - gbeto 12:21:24 04/30/12 Make sure your idler pulleys are torqued down properly (n/m) - AHos(Chicago) 13:13:38 04/30/12 Re: Make sure your idler pulleys are torqued down properly - mkhoid 06:59:03 05/01/12 Do you have the large washers on both sides of the crank - Evan_Wright (Ca) 14:15:27 04/30/12 holly.... - gbeto 15:47:10 04/30/12
Post a Followup	You cannot reply to this message because you are not logged in.