Subject	Did you install a new harness?
Posted by	toykoz32 on April 28, 2012 at 6:55 PM
	This message has been viewed 93 times.
In Reply To	Build Not starting! posted by dzero196 on April 26, 2012 at 07:08 PM
Message	If so check all the connections. I had the same problem ended up being a connection not completely seated, Drove the car around the block, wiped down the engine bay no start, no spark. It was one of the connectors near the large fuse box on the driver side. Remove and reconnect, mine looked connected/seated and it wasn't. I hope this is the case for you.
Follow Ups	Build Not starting! - dzero196 19:08:33 04/26/12 By "no power" do you mean there is no voltage on either - DVDBURN (MD) 20:08:15 04/26/12 Re: By "no power" do you mean there is no voltage on either - dzero196 23:04:04 04/26/12 Have you checked your PTU? - KongZTT GT28RS MD 23:11:40 04/26/12 Re: Have you checked your PTU? - dzero196 11:32:24 04/27/12 It does not.. but you mentioned no spark at first.. - KongZTT GT28RS MD 19:32:43 04/27/12 Thats a good one, Iv seen that one several times (n/m) - toykoz32 18:37:05 04/29/12 Did you install a new harness? - toykoz32 18:55:09 04/28/12
Post a Followup	You cannot reply to this message because you are not logged in.