Subject	I did it just last week with the tranny off.
Posted by	fuzzymonkey on April 27, 2012 at 2:22 PM
	This message has been viewed 355 times.
In Reply To	I would not bypass the det sensor. Just relocate it. posted by Draker (Eugene, OR) on April 27, 2012 at 11:17 AM
Message	took 30 minutes tops after tranny pulled. It is pretty deep however. After getting the bolt initially loosened, you'll need to unscrew the bolt with your fingertips. Putting it back in was a bit tough with the ridge and knock falling over before getting the bolt threaded. TIP: remove subharness first. Hopefully it yanks off, or like me, broke the connector on the old knock sensor off. Easily do-able.
Follow Ups	intake manifold maintenance - Jiro 01:46:33 04/27/12 Those are just plugs for the back of your two exhaust valve - mkhoid 06:36:49 04/27/12 I would not bypass the det sensor. Just relocate it. - Draker (Eugene, OR) 11:17:23 04/27/12 I did it just last week with the tranny off. - fuzzymonkey 14:22:04 04/27/12 Assuming your EGR is deleted? (n/m) - OverZealous (CT) 23:50:43 04/27/12 also, relocating is stupid. The sensor does nothing - fuzzymonkey 14:23:34 04/27/12 What experience is that? (n/m) - OverZealous (CT) 23:41:58 04/27/12 There was a guy on here selling VTC end caps. - Draker (Eugene, OR) 11:20:14 04/27/12 Though not related to a plenum pull I would replace the >>> - ZUL8TR 13:39:59 04/28/12
Post a Followup	You cannot reply to this message because you are not logged in.