Subject	By "no power" do you mean there is no voltage on either
Posted by	DVDBURN (MD) on April 26, 2012 at 8:08 PM
	This message has been viewed 131 times.
In Reply To	Build Not starting! posted by dzero196 on April 26, 2012 at 07:08 PM
Message	side of the injector pins? If not, check the fuses in the small fuse box in front of the battery. If you have voltage to the injectors but the injectors are not operating, check the power to the CAS (one wire should have battery voltage) and the signals from the CAS (5 volt pulses). If the ECU does not get the pulse signals from the CAS on pins 41 and 42 the coils and injectors will not operate. Other than that, check the ECU connector and the voltage powering the ECU. www.mytwinturbo.com Nissan Data Voice - The first Nissan diagnostic software with a voice! Nissan Data Voice on YouTube Download my Nissan 300ZX Vin/Model Lookup. Watch an ECZA meet caravan!
Follow Ups	Build Not starting! - dzero196 19:08:33 04/26/12 By "no power" do you mean there is no voltage on either - DVDBURN (MD) 20:08:15 04/26/12 Re: By "no power" do you mean there is no voltage on either - dzero196 23:04:04 04/26/12 Have you checked your PTU? - KongZTT GT28RS MD 23:11:40 04/26/12 Re: Have you checked your PTU? - dzero196 11:32:24 04/27/12 It does not.. but you mentioned no spark at first.. - KongZTT GT28RS MD 19:32:43 04/27/12 Thats a good one, Iv seen that one several times (n/m) - toykoz32 18:37:05 04/29/12 Did you install a new harness? - toykoz32 18:55:09 04/28/12
Post a Followup	You cannot reply to this message because you are not logged in.