Subject	Yes, and I would probably do the same thing
Posted by	Stadsport (PHX) on April 25, 2012 at 12:17 AM
	This message has been viewed 194 times.
In Reply To	3 speed fuel pump wiring... posted by evan_aggie(ATX) on April 24, 2012 at 10:40 PM
Message	But in every swap I've worked on I just chip the NA ECU and install a TT fuel pump.
Follow Ups	3 speed fuel pump wiring... - evan_aggie(ATX) 22:40:57 04/24/12 that new wire was supposed to go from the ECU to the FPC (n/m) - evan_aggie(ATX) 22:44:02 04/24/12 The connector is on the back side of the fuse block. - Woody75 (Denver) 23:09:13 04/24/12 Which front side connector? I was not able to identify - evan_aggie(ATX) 23:25:00 04/24/12 It's been awhile since I did. - Woody75 (Denver) 00:02:19 04/25/12 That blue plug must be behind all of that junk. Can't I - evan_aggie(ATX) 07:38:57 04/25/12 Yes, you could go direct end to end. - Woody75 (Denver) 09:13:00 04/25/12 You think a 15A fuse is appropriate for that wire? (n/m) - evan_aggie(ATX) 11:03:45 04/25/12 I would have to look over the wiring chart, but - Woody75 (Denver) 13:38:17 04/25/12 I thought that was the whole purpose of the purple wire - evan_aggie(ATX) 13:43:45 04/25/12 The connection is just part of the fuse box assembly. - Woody75 (Denver) 14:47:38 04/25/12 Yes, and I would probably do the same thing - Stadsport (PHX) 00:17:11 04/25/12 I did that, but the whirring under even a relatively light - evan_aggie(ATX) 07:34:06 04/25/12 I don't think it's bogus but... - Stadsport (PHX) 17:01:40 04/25/12
Post a Followup	You cannot reply to this message because you are not logged in.