TwinTurbo.NET: Nissan 300ZX forum - update..
People Seeking Info
 
   


     
Subject update..
     
Posted by MoGaffar on April 22, 2012 at 3:29 PM
  This message has been viewed 189 times.
     
In Reply To ECU Pin 16 high voltage posted by MoGaffar on April 19, 2012 at 10:35 AM
     
Message I took off an ecu from an 90 NA and used that to test the voltage so I wouldn't ruin my TT Ecu. When I have everything connected ecu included and turn the ignition on I get the FSM stated .8 volts but within 6 seconds it jumps to 12 volts.

Also when it jumps to 12 volts the ignition relay clicks. Im assuming that something is causing the ignition relay to trip. Im pretty sure the ecu is good because within those 6 seconds ill get it into diagnostic mode and it will spit out one code before the light turns off.

___________________________________________________________


"She's always wet and hot and purrs when I slide inside of her. She screams when I put my foot down and isn't too hard to control. She is usually straight but she slides her rear out when I ask her too. Always gives me a boost. Stays with me and leaves the other guys behind. She is even more fun when her top is off...so free. Sometimes a friend will join in, male or female, and we both enjoy her. Plus she is a non smoker...what more can you ask for?" ***taken from ScottyFender***

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.