Subject	All that's bittersweet
Posted by	Stadsport (PHX) on April 20, 2012 at 1:07 AM
	This message has been viewed 117 times.
In Reply To	nope posted by aliaZ on April 19, 2012 at 05:08 PM
Message	The oil cooler I'm getting uses -10 AN fittings, but for compatibility with the stock oil tree I was going to just run it with a reducer to -6 AN and run -6 AN hoses to the oil tree. So I guess I'll just use conventional rubber hoses or something, and replace it all with -10 AN all the way back when it comes time to install an oil filter tree. I have practically I experience working with AN fittings, but it's my understanding that a -6 AN hose barb is a perfect fit for 3/8" hose.
Follow Ups	Stock Oil Cooler lines - 3/8" or 5/8"? (n/m) - Stadsport (PHX) 06:33:23 04/19/12 closer to 3/8, but is a tight fit (n/m) - aliaZ 08:13:46 04/19/12 Think a -6 AN rubber/braided SS would fit okay? (n/m) - Stadsport (PHX) 12:29:08 04/19/12 nope - aliaZ 17:08:05 04/19/12 All that's bittersweet - Stadsport (PHX) 01:07:14 04/20/12 Hope this helps. This is a link to my install of an - zICEman(East TN) 10:36:44 04/20/12 It does, thanks. Did you use -10 or - 6 hoses? (n/m) - Stadsport (PHX) 17:57:06 04/20/12 I used the Z1 kit that has -8AN fittings. - zICEman(East TN) 09:11:21 04/21/12
Post a Followup	You cannot reply to this message because you are not logged in.