TwinTurbo.NET: Nissan 300ZX forum - Re: Do the fuel pressure test and verify! Don't over look it.
Subject
Re: Do the fuel pressure test and verify! Don't over look it.
Posted by
Dawei
on April 18, 2012 at 5:22 PM
This message has been viewed
187
times.
In Reply To
Do the fuel pressure test and verify! Don't over look it.
posted by Draker (Eugene, OR)
on April 18, 2012 at 10:21 AM
Message
Will do, thanks.
Follow Ups
Mystery that neither a shop nor I can figure out.
-
Dawei
21:26:41 04/17/12
Re: Mystery that neither a shop nor I can figure out.
-
nzryan
22:06:16 04/17/12
Re: Re: Mystery that neither a shop nor I can figure out.
-
Dawei
22:34:49 04/17/12
Re: Re: Re: Mystery that neither a shop nor I can figure out.
-
mkhoid
16:53:41 04/18/12
Pinched injector O-ring
-
Draker (Eugene, OR)
22:06:19 04/17/12
Re: Pinched injector O-ring
-
Dawei
22:33:00 04/17/12
Re: Mystery that neither a shop nor I can figure out.
-
mkhoid
22:10:29 04/17/12
Re: Re: Mystery that neither a shop nor I can figure out.
-
Dawei
22:31:44 04/17/12
Re: Re: Re: Mystery that neither a shop nor I can figure out.
-
mkhoid
23:24:10 04/17/12
Re: Re: Re: Re: Mystery that neither a shop nor I can figure out.
-
Dawei
00:02:12 04/18/12
Do the fuel pressure test and verify! Don't over look it.
-
Draker (Eugene, OR)
10:21:57 04/18/12
Re: Do the fuel pressure test and verify! Don't over look it. -
Dawei
17:22:01 04/18/12
I wonder if there's a possibility you were sent the wrong
-
Evan_Wright (Ca)
00:42:05 04/18/12
Re: I wonder if there's a possibility you were sent the wrong
-
Dawei
00:50:29 04/18/12
Re: I wonder if there's a possibility you were sent the wrong
-
Dawei
01:08:07 04/18/12
Re: Re: I wonder if there's a possibility you were sent the wrong
-
lurker_nz
02:16:59 04/18/12
Re: Re: Re: I wonder if there's a possibility you were sent the wrong
-
Dawei
02:31:38 04/18/12
Ive did the dremel method and it works amazing.
-
JoshE300zxTT
09:00:18 04/18/12
2nd (n/m)
-
OverZealous (CT)
17:24:49 04/19/12
Re: I wonder if there's a possibility you were sent the wrong
-
Dawei
21:22:01 04/18/12
You need to have them flow tested. Pull the plenum and
-
Evan_Wright (Ca)
22:50:09 04/18/12
Post a
Followup
You cannot reply to this message because you are not
logged in
.