Subject	Re: Re: Re: I wonder if there's a possibility you were sent the wrong
Posted by	Dawei on April 18, 2012 at 2:31 AM
	This message has been viewed 160 times.
In Reply To	Re: Re: I wonder if there's a possibility you were sent the wrong posted by lurker_nz on April 18, 2012 at 02:16 AM
Message	I know about the Dremel Method, I'm a little concerned about fubaring my plenum, plus I would almost certainly need to remove all 6 injectors if they are indeed too big. Does anyone have any other ideas as to potential problems? The injectors are very suspect, but taking off the plenum again sounds like very little fun, and I trust the guy that sold me these. (calling him again tomorrow anyway)
Follow Ups	Mystery that neither a shop nor I can figure out. - Dawei 21:26:41 04/17/12 Re: Mystery that neither a shop nor I can figure out. - nzryan 22:06:16 04/17/12 Re: Re: Mystery that neither a shop nor I can figure out. - Dawei 22:34:49 04/17/12 Re: Re: Re: Mystery that neither a shop nor I can figure out. - mkhoid 16:53:41 04/18/12 Pinched injector O-ring - Draker (Eugene, OR) 22:06:19 04/17/12 Re: Pinched injector O-ring - Dawei 22:33:00 04/17/12 Re: Mystery that neither a shop nor I can figure out. - mkhoid 22:10:29 04/17/12 Re: Re: Mystery that neither a shop nor I can figure out. - Dawei 22:31:44 04/17/12 Re: Re: Re: Mystery that neither a shop nor I can figure out. - mkhoid 23:24:10 04/17/12 Re: Re: Re: Re: Mystery that neither a shop nor I can figure out. - Dawei 00:02:12 04/18/12 Do the fuel pressure test and verify! Don't over look it. - Draker (Eugene, OR) 10:21:57 04/18/12 Re: Do the fuel pressure test and verify! Don't over look it. - Dawei 17:22:01 04/18/12 I wonder if there's a possibility you were sent the wrong - Evan_Wright (Ca) 00:42:05 04/18/12 Re: I wonder if there's a possibility you were sent the wrong - Dawei 00:50:29 04/18/12 Re: I wonder if there's a possibility you were sent the wrong - Dawei 01:08:07 04/18/12 Re: Re: I wonder if there's a possibility you were sent the wrong - lurker_nz 02:16:59 04/18/12 Re: Re: Re: I wonder if there's a possibility you were sent the wrong - Dawei 02:31:38 04/18/12 Ive did the dremel method and it works amazing. - JoshE300zxTT 09:00:18 04/18/12 2nd (n/m) - OverZealous (CT) 17:24:49 04/19/12 Re: I wonder if there's a possibility you were sent the wrong - Dawei 21:22:01 04/18/12 You need to have them flow tested. Pull the plenum and - Evan_Wright (Ca) 22:50:09 04/18/12
Post a Followup	You cannot reply to this message because you are not logged in.