Subject	Pinched injector O-ring
Posted by	Draker (Eugene, OR) on April 17, 2012 at 10:06 PM
	This message has been viewed 305 times.
In Reply To	Mystery that neither a shop nor I can figure out. posted by Dawei on April 17, 2012 at 09:26 PM
Message	Did your mechanic do a leak down test on the injectors and fuel system? Should hold fuel pressure with the key off.
Follow Ups	Mystery that neither a shop nor I can figure out. - Dawei 21:26:41 04/17/12 Re: Mystery that neither a shop nor I can figure out. - nzryan 22:06:16 04/17/12 Re: Re: Mystery that neither a shop nor I can figure out. - Dawei 22:34:49 04/17/12 Re: Re: Re: Mystery that neither a shop nor I can figure out. - mkhoid 16:53:41 04/18/12 Pinched injector O-ring - Draker (Eugene, OR) 22:06:19 04/17/12 Re: Pinched injector O-ring - Dawei 22:33:00 04/17/12 Re: Mystery that neither a shop nor I can figure out. - mkhoid 22:10:29 04/17/12 Re: Re: Mystery that neither a shop nor I can figure out. - Dawei 22:31:44 04/17/12 Re: Re: Re: Mystery that neither a shop nor I can figure out. - mkhoid 23:24:10 04/17/12 Re: Re: Re: Re: Mystery that neither a shop nor I can figure out. - Dawei 00:02:12 04/18/12 Do the fuel pressure test and verify! Don't over look it. - Draker (Eugene, OR) 10:21:57 04/18/12 Re: Do the fuel pressure test and verify! Don't over look it. - Dawei 17:22:01 04/18/12 I wonder if there's a possibility you were sent the wrong - Evan_Wright (Ca) 00:42:05 04/18/12 Re: I wonder if there's a possibility you were sent the wrong - Dawei 00:50:29 04/18/12 Re: I wonder if there's a possibility you were sent the wrong - Dawei 01:08:07 04/18/12 Re: Re: I wonder if there's a possibility you were sent the wrong - lurker_nz 02:16:59 04/18/12 Re: Re: Re: I wonder if there's a possibility you were sent the wrong - Dawei 02:31:38 04/18/12 Ive did the dremel method and it works amazing. - JoshE300zxTT 09:00:18 04/18/12 2nd (n/m) - OverZealous (CT) 17:24:49 04/19/12 Re: I wonder if there's a possibility you were sent the wrong - Dawei 21:22:01 04/18/12 You need to have them flow tested. Pull the plenum and - Evan_Wright (Ca) 22:50:09 04/18/12
Post a Followup	You cannot reply to this message because you are not logged in.