Subject	removing rear crank bushing from an automatic
Posted by	8zenmind8 on December 27, 2011 at 6:42 PM
	This message has been viewed 197 times.
Message	Hi there happy holidays. My previous engine has had many issues, from leaking vacuum/ fuel hoses to blown out turbos, consequently i plan on swapping out the motor. I bought a motor from a 93 z32 twin turbo; however, the engine that i received was from an automatic and my car is a manual. The owner let me know that the rear crank shaft bushing must be removed in order for proper functioning. I've tried drilling out two holes then sticking a screw driver vertically through it and then using a slide hammer. However, this was unsuccessful. Any advice on other posssible methods to remove the bushing would be greatly appreciated. -Anthony
Follow Ups	removing rear crank bushing from an automatic - 8zenmind8 18:42:49 12/27/11 Re: removing rear crank bushing from an automatic - spyder46 16:28:52 12/31/11
Post a Followup	You cannot reply to this message because you are not logged in.