Subject	Alignment tool sagging when tightening clutch?
Posted by	HillZTT on November 16, 2011 at 11:03 AM
	This message has been viewed 156 times.
In Reply To	Yup. I put the bushing over the trans shaft before hand. posted by evan_aggie(ATX) on November 15, 2011 at 02:37 PM
Message	I've found it helps to see how much vertical play there is with the alignment tool, then just hold it near center while snugging up the first couple of bolts. ------------------ Tada! "Low compression in cylinder 6."
Follow Ups	Anyone have extra advice for transmission install? - evan_aggie(ATX) 09:16:22 11/15/11 If I remember correctly you used a jspec engine correct? - Woody75 (Denver) 09:50:21 11/15/11 It was a 5spd JDM. - evan_aggie(ATX) 10:21:47 11/15/11 Oh, and a related question: On the battery cable, there is - evan_aggie(ATX) 10:34:53 11/15/11 Goes on the top tranny bolt. - Woody75 (Denver) 11:32:21 11/15/11 Did you measure? Do you know for sure that the - zellamay 11:13:36 11/15/11 Yup. I put the bushing over the trans shaft before hand. - evan_aggie(ATX) 14:37:27 11/15/11 Alignment tool sagging when tightening clutch? - HillZTT 11:03:01 11/16/11 Top two bolts clear of the trans tunnel? - BoneZ (MD) 11:56:51 11/15/11 Re: Top two bolts clear of the trans tunnel? - jaidieray 20:15:18 11/15/11 If you're using a clutch alignment tool, you need to make - Dave N 18:05:12 11/16/11 victory! - evan_aggie(ATX) 07:49:33 11/17/11 Congrats, I've done the job 3 times now >> - my91z 16:10:56 11/17/11
Post a Followup	You cannot reply to this message because you are not logged in.