Subject	did you check continuity between the signal wire and ground?
Posted by	aliaZ on November 15, 2011 at 10:48 PM
	This message has been viewed 163 times.
In Reply To	Still Code 34!! Wtf!!! posted by 91FairladyTT on November 15, 2011 at 06:50 PM
Message	There should be no continuity between signal and ground...if there is you have an EFI harness issue. I had this happen on my 240sx...there was even a TSB on it. The problem was solved by cutting the sheilding on the signal wire, which had apparently grounded out the signal wire due to a fault in the harness.
Follow Ups	Still Code 34!! Wtf!!! - 91FairladyTT 18:50:21 11/15/11 The ECU. (n/m) - Draker (Eugene, OR) 21:38:03 11/15/11 did you check continuity between the signal wire and ground? - aliaZ 22:48:42 11/15/11
Post a Followup	You cannot reply to this message because you are not logged in.