Subject	Yup. I put the bushing over the trans shaft before hand.
Posted by	evan_aggie(ATX) on November 15, 2011 at 2:37 PM
	This message has been viewed 164 times.
In Reply To	Did you measure? Do you know for sure that the posted by zellamay on November 15, 2011 at 11:13 AM
Message	Just to check that it did indeed fit. How else can the clutch be aligned? I used the tool, installed the clutch, pressure plate, bolted everything down... it should be fine. I guess you guys are probably right...I just need to try again...go at it from a few different angles (that's what she said?) and it'll magically slide right in. I was getting really pissed last night and sore trying to lift that bad boy off the trans jack and push it in....
Follow Ups	Anyone have extra advice for transmission install? - evan_aggie(ATX) 09:16:22 11/15/11 If I remember correctly you used a jspec engine correct? - Woody75 (Denver) 09:50:21 11/15/11 It was a 5spd JDM. - evan_aggie(ATX) 10:21:47 11/15/11 Oh, and a related question: On the battery cable, there is - evan_aggie(ATX) 10:34:53 11/15/11 Goes on the top tranny bolt. - Woody75 (Denver) 11:32:21 11/15/11 Did you measure? Do you know for sure that the - zellamay 11:13:36 11/15/11 Yup. I put the bushing over the trans shaft before hand. - evan_aggie(ATX) 14:37:27 11/15/11 Alignment tool sagging when tightening clutch? - HillZTT 11:03:01 11/16/11 Top two bolts clear of the trans tunnel? - BoneZ (MD) 11:56:51 11/15/11 Re: Top two bolts clear of the trans tunnel? - jaidieray 20:15:18 11/15/11 If you're using a clutch alignment tool, you need to make - Dave N 18:05:12 11/16/11 victory! - evan_aggie(ATX) 07:49:33 11/17/11 Congrats, I've done the job 3 times now >> - my91z 16:10:56 11/17/11
Post a Followup	You cannot reply to this message because you are not logged in.