Subject	Top two bolts clear of the trans tunnel?
Posted by	BoneZ (MD) on November 15, 2011 at 11:56 AM
	This message has been viewed 170 times.
In Reply To	Anyone have extra advice for transmission install? posted by evan_aggie(ATX) on November 15, 2011 at 09:16 AM
Message	I've had the best and most consistent success by getting it where you have it, then picking it up off the jack (I use a floor jack) with my hands and knees and guiding it in~ smooth as butter! ;P It's still a bitch though! -___________________________________________________________-
Follow Ups	Anyone have extra advice for transmission install? - evan_aggie(ATX) 09:16:22 11/15/11 If I remember correctly you used a jspec engine correct? - Woody75 (Denver) 09:50:21 11/15/11 It was a 5spd JDM. - evan_aggie(ATX) 10:21:47 11/15/11 Oh, and a related question: On the battery cable, there is - evan_aggie(ATX) 10:34:53 11/15/11 Goes on the top tranny bolt. - Woody75 (Denver) 11:32:21 11/15/11 Did you measure? Do you know for sure that the - zellamay 11:13:36 11/15/11 Yup. I put the bushing over the trans shaft before hand. - evan_aggie(ATX) 14:37:27 11/15/11 Alignment tool sagging when tightening clutch? - HillZTT 11:03:01 11/16/11 Top two bolts clear of the trans tunnel? - BoneZ (MD) 11:56:51 11/15/11 Re: Top two bolts clear of the trans tunnel? - jaidieray 20:15:18 11/15/11 If you're using a clutch alignment tool, you need to make - Dave N 18:05:12 11/16/11 victory! - evan_aggie(ATX) 07:49:33 11/17/11 Congrats, I've done the job 3 times now >> - my91z 16:10:56 11/17/11
Post a Followup	You cannot reply to this message because you are not logged in.