Subject	injectors ohm 11.3-11.4... i spin the CAS and i connected
Posted by	GitNMyBelly on November 11, 2011 at 12:44 PM
	This message has been viewed 171 times.
In Reply To	Ohm meter or spare inj hooked up but laying in your hand. posted by Woody75 (Denver) on November 09, 2011 at 12:49 PM
Message	old injectors to the connector and they click. so i guess that leaves me to spark? i dont think i am getting signal to the coil packs, because if i swap coil packs its the same thing. 1 and 5 are not firing.
Follow Ups	how can you tell when a coil pack goes bad??? - GitNMyBelly 13:29:00 11/08/11 power balance test - zgene4 13:56:14 11/08/11 Re: power balance test - GitNMyBelly 13:58:37 11/08/11 cause it's probably your injector - zgene4 14:01:19 11/08/11 Re: cause it's probably your injector - Krazyd27 15:10:18 11/08/11 Re: cause it's probably your injector - Krazyd27 15:10:49 11/08/11 Swap with another coil pack and see if it follows. - cherryz 14:38:45 11/08/11 What do nismo 555injectors ohm at? (n/m) - GitNMyBelly 17:51:50 11/08/11 healthy ones should be 10-14ohms - typically 10.9 ish (n/m) - Bernie (NoVA) 21:54:03 11/08/11 dying injector. (n/m) - Bernie (NoVA) 21:54:51 11/08/11 swapped out injector that read 30ohms. now other 2 - GitNMyBelly 10:43:35 11/09/11 how can i test the signal going to the injectors? or what - GitNMyBelly 10:57:30 11/09/11 Ohm meter or spare inj hooked up but laying in your hand. - Woody75 (Denver) 12:49:51 11/09/11 injectors ohm 11.3-11.4... i spin the CAS and i connected - GitNMyBelly 12:44:52 11/11/11
Post a Followup	You cannot reply to this message because you are not logged in.