Subject	Yeah, that may be what I'll have to do.
Posted by	pa300 on November 11, 2011 at 5:50 AM
	This message has been viewed 131 times.
In Reply To	Not unusual for the code to be thrown due to a posted by jzack on November 10, 2011 at 10:28 PM
Message	But the one sensor was pretty dirty and covered in metal shavings, so I'd like to try clearing the codes first before I spend money on a sensor. Thanks for the idea of checking the resistance. I may try that. -Eric
Follow Ups	ABS light is on. Is there a write-up on how to clean sensors - pa300 06:18:52 11/10/11 Re: ABS light is on. Is there a write-up on how to clean sensors - lurker_nz 13:56:04 11/10/11 Thanks, I did clean the effected sensors ----> - pa300 15:41:13 11/10/11 Is there any guru's out there that can help? - pa300 16:47:48 11/10/11 ... - thumper 17:16:42 11/10/11 Thank you very much for your genial attempt to help. - pa300 17:43:50 11/10/11 reading the FSM - thumper 18:04:26 11/10/11 OK, thanks. I tried that, and the light is still on. - pa300 18:25:36 11/10/11 Not unusual for the code to be thrown due to a - jzack 22:28:49 11/10/11 Yeah, that may be what I'll have to do. - pa300 05:50:07 11/11/11 There's actually an LED on the ABS control unit - thumper 22:34:33 11/10/11 No problem. I believe that at sometime in 94 they began.. - pa300 05:46:24 11/11/11 On a side note, is your screen name a reference ---> - pa300 17:45:42 11/10/11 :) - thumper 18:05:33 11/10/11
Post a Followup	You cannot reply to this message because you are not logged in.