Subject	OK, thanks. I tried that, and the light is still on.
Posted by	pa300 on November 10, 2011 at 6:25 PM
	This message has been viewed 116 times.
In Reply To	reading the FSM posted by thumper on November 10, 2011 at 06:04 PM
Message	When I turn the key to "on" the ABS light comes on, flickers off for a moment and then stays lit. Does that sound like a code 1 to you? It doesn't to me. It should blink for a code. I'm just going to clean all the sensors real well and then pay someone to clear the ABS codes. Then if it comes back on I can see what is still bothering it. Thanks for your help. -Eric
Follow Ups	ABS light is on. Is there a write-up on how to clean sensors - pa300 06:18:52 11/10/11 Re: ABS light is on. Is there a write-up on how to clean sensors - lurker_nz 13:56:04 11/10/11 Thanks, I did clean the effected sensors ----> - pa300 15:41:13 11/10/11 Is there any guru's out there that can help? - pa300 16:47:48 11/10/11 ... - thumper 17:16:42 11/10/11 Thank you very much for your genial attempt to help. - pa300 17:43:50 11/10/11 reading the FSM - thumper 18:04:26 11/10/11 OK, thanks. I tried that, and the light is still on. - pa300 18:25:36 11/10/11 Not unusual for the code to be thrown due to a - jzack 22:28:49 11/10/11 Yeah, that may be what I'll have to do. - pa300 05:50:07 11/11/11 There's actually an LED on the ABS control unit - thumper 22:34:33 11/10/11 No problem. I believe that at sometime in 94 they began.. - pa300 05:46:24 11/11/11 On a side note, is your screen name a reference ---> - pa300 17:45:42 11/10/11 :) - thumper 18:05:33 11/10/11
Post a Followup	You cannot reply to this message because you are not logged in.