Subject	Thanks, I did clean the effected sensors ---->
Posted by	pa300 on November 10, 2011 at 3:41 PM
	This message has been viewed 135 times.
In Reply To	Re: ABS light is on. Is there a write-up on how to clean sensors posted by lurker_nz on November 10, 2011 at 01:56 PM
Message	They were pretty dirty, especially one side. So I was wondering how I can clear ABS codes, to see if I fixed the problem. Does anyone know how to do it? The only thing I found is the FAQ about how to clear ECU codes. Will this also clear the abs codes? Thnaks for the help
Follow Ups	ABS light is on. Is there a write-up on how to clean sensors - pa300 06:18:52 11/10/11 Re: ABS light is on. Is there a write-up on how to clean sensors - lurker_nz 13:56:04 11/10/11 Thanks, I did clean the effected sensors ----> - pa300 15:41:13 11/10/11 Is there any guru's out there that can help? - pa300 16:47:48 11/10/11 ... - thumper 17:16:42 11/10/11 Thank you very much for your genial attempt to help. - pa300 17:43:50 11/10/11 reading the FSM - thumper 18:04:26 11/10/11 OK, thanks. I tried that, and the light is still on. - pa300 18:25:36 11/10/11 Not unusual for the code to be thrown due to a - jzack 22:28:49 11/10/11 Yeah, that may be what I'll have to do. - pa300 05:50:07 11/11/11 There's actually an LED on the ABS control unit - thumper 22:34:33 11/10/11 No problem. I believe that at sometime in 94 they began.. - pa300 05:46:24 11/11/11 On a side note, is your screen name a reference ---> - pa300 17:45:42 11/10/11 :) - thumper 18:05:33 11/10/11
Post a Followup	You cannot reply to this message because you are not logged in.