Subject	Re: Did you already remove the stud that stripped?
Posted by	Z3r0 on November 08, 2011 at 1:25 PM
	This message has been viewed 113 times.
In Reply To	Did you already remove the stud that stripped? posted by Draker (Eugene, OR) on November 08, 2011 at 12:56 PM
Message	i took out the cylinder head bolt and on the bottom of the threads of the bolt i see some metal shavings. the bolt and the threads of bolt is fine im sure of that. the threads inside the block have been stripped
Follow Ups	stripped thread on engine block :( - Z3r0 10:47:43 11/08/11 Did you already remove the stud that stripped? - Draker (Eugene, OR) 12:56:44 11/08/11 Re: Did you already remove the stud that stripped? - Z3r0 13:25:18 11/08/11 I think Heli-coil might be your best bet. (n/m) - MixManMash 16:42:46 11/08/11 Timesert > Heli-coil IMO. (n/m) - Draker (Eugene, OR) 16:59:21 11/08/11 After seeing that, agreed. (n/m) - MixManMash 17:10:16 11/08/11 You will need this. - Draker (Eugene, OR) 16:48:25 11/08/11 Are you sure you put the correct bolt in the correct hole? - toykoz32 18:14:39 11/08/11 Look at step 6 here, it shows the odd bolt holes - BoneZ (MD) 19:58:53 11/08/11
Post a Followup	You cannot reply to this message because you are not logged in.