Subject	Did you already remove the stud that stripped?
Posted by	Draker (Eugene, OR) on November 08, 2011 at 12:56 PM
	This message has been viewed 103 times.
In Reply To	stripped thread on engine block :( posted by Z3r0 on November 08, 2011 at 10:47 AM
Message	Did it strip on the top of the stud.. or bottom? I would pull it out and see if the threads on the stud stripped, if the stud snapped off, or if it stripped the threads in the block.
Follow Ups	stripped thread on engine block :( - Z3r0 10:47:43 11/08/11 Did you already remove the stud that stripped? - Draker (Eugene, OR) 12:56:44 11/08/11 Re: Did you already remove the stud that stripped? - Z3r0 13:25:18 11/08/11 I think Heli-coil might be your best bet. (n/m) - MixManMash 16:42:46 11/08/11 Timesert > Heli-coil IMO. (n/m) - Draker (Eugene, OR) 16:59:21 11/08/11 After seeing that, agreed. (n/m) - MixManMash 17:10:16 11/08/11 You will need this. - Draker (Eugene, OR) 16:48:25 11/08/11 Are you sure you put the correct bolt in the correct hole? - toykoz32 18:14:39 11/08/11 Look at step 6 here, it shows the odd bolt holes - BoneZ (MD) 19:58:53 11/08/11
Post a Followup	You cannot reply to this message because you are not logged in.