Subject	stripped thread on engine block :(
Posted by	Z3r0 on November 08, 2011 at 10:47 AM
	This message has been viewed 114 times.
Message	so i was finishing my project tt and now im bolting down the cylinder head bolts with the same specs and process provided from the service manual and on the LAST bolt i was tightening it to the specs provided and it somehow strips and the bolt keeps turning. is this common? what can i do now?
Follow Ups	stripped thread on engine block :( - Z3r0 10:47:43 11/08/11 Did you already remove the stud that stripped? - Draker (Eugene, OR) 12:56:44 11/08/11 Re: Did you already remove the stud that stripped? - Z3r0 13:25:18 11/08/11 I think Heli-coil might be your best bet. (n/m) - MixManMash 16:42:46 11/08/11 Timesert > Heli-coil IMO. (n/m) - Draker (Eugene, OR) 16:59:21 11/08/11 After seeing that, agreed. (n/m) - MixManMash 17:10:16 11/08/11 You will need this. - Draker (Eugene, OR) 16:48:25 11/08/11 Are you sure you put the correct bolt in the correct hole? - toykoz32 18:14:39 11/08/11 Look at step 6 here, it shows the odd bolt holes - BoneZ (MD) 19:58:53 11/08/11
Post a Followup	You cannot reply to this message because you are not logged in.