Subject	It's a straight wire I am pretty sure?
Posted by	Draker (Eugene, OR) on October 30, 2011 at 12:07 PM
	This message has been viewed 129 times.
In Reply To	yes i just measured threw the ECU harness and got some posted by JoshE300zxTT on October 30, 2011 at 07:36 AM
Message	Should be very close to zero ohms. Others please correct me if I'm wrong here. Are you sure this was pin 23? There is only one wire that goes back to the ECU. Make sure you are not measuring through the knock sensor or it's sub-harness.
Follow Ups	Battling code 34...still - JoshE300zxTT 15:25:49 10/29/11 Did you already measure through the harness to the ECU? - Draker (Eugene, OR) 02:03:45 10/30/11 yes i just measured threw the ECU harness and got some - JoshE300zxTT 07:36:43 10/30/11 It's a straight wire I am pretty sure? - Draker (Eugene, OR) 12:07:32 10/30/11 i will have to double check because the harnees that i - JoshE300zxTT 17:12:18 10/30/11 here is a picture of the connector i measured the resistance - JoshE300zxTT 17:46:43 10/30/11 This is the right one. - Draker (Eugene, OR) 18:38:14 10/30/11 thats 513 ohms. consider that bad lol - Dane (Houston) 15:02:35 11/02/11 Re: Battling code 34...still - craigz96tt 10:23:53 10/30/11 Re: Re: Battling code 34...still - Bo (Houston) 14:14:45 10/30/11 im pretty sure it does retard the timing any time the code - JoshE300zxTT 17:13:47 10/30/11 I don't have safety boost w my jwt ecu runs strong (n/m) - craigz96tt 10:31:47 10/31/11 so you keep getting an intermitten code 34? - JoshE300zxTT 07:27:01 11/02/11 Sure it kills your power and boost, but it's saves your - Bo (Houston) 18:54:40 10/30/11 yea im 100% sure, there is no banging or pinging in the - JoshE300zxTT 07:25:36 11/02/11 34 is for knock circuit failure, not knock being detected (n/m) - Dane (Houston) 14:49:25 11/02/11 Re: Battling code 34...still - AsaHerring 10:42:03 11/03/11 i have pretty much did everything you have done! - JoshE300zxTT 15:25:49 11/03/11 A 100K ohm resistor going from the knock sensor ECU pin then - TTNIckdizzle 11:34:00 11/04/11
Post a Followup	You cannot reply to this message because you are not logged in.