Subject	I've not seen or heard this with the vg30's
Posted by	thumper on October 27, 2011 at 3:21 PM
	This message has been viewed 121 times.
In Reply To	Hey Thumper, even if I did not have to resize the rods I posted by Wright (Ca) on October 26, 2011 at 05:12 PM
Message	I'm pretty sure you can just reuse the rod if there's been no damage. Anyone else chime in if I'm incorrect. I've had the machine shop check rods for straightness before, but I've never had them resized...
Follow Ups	Replacing rod and main bearings... - Wright (Ca) 11:27:04 10/26/11 Also, I was planning on ordering bearing grades based off of - Wright (Ca) 11:44:32 10/26/11 Re: Replacing rod and main bearings... - lurker_nz 13:44:01 10/26/11 It appears he's wanting to do this himself... - thumper 14:06:35 10/26/11 Thanks for the replies. - Wright (Ca) 14:55:59 10/26/11 Rods - bolts not studs - thumper 15:07:28 10/26/11 My spare engine has studs...maybe not oem? - Wright (Ca) 15:16:00 10/26/11 That's not a stud - thumper 15:23:03 10/26/11 Ahh, I see. Thanks for the clarification. - Wright (Ca) 15:27:37 10/26/11 I just read that the rods need to be re-sized if I replace - Wright (Ca) 16:29:06 10/26/11 citation? (n/m) - thumper 16:51:31 10/26/11 Hey Thumper, even if I did not have to resize the rods I - Wright (Ca) 17:12:04 10/26/11 I've not seen or heard this with the vg30's - thumper 15:21:28 10/27/11 Re: I've not seen or heard this with the vg30's - jaidieray 19:36:46 10/27/11 That's all great information straight out of the FSM, but - thumper 19:51:41 10/27/11 Re: That's all great information straight out of the FSM, but - jaidieray 16:53:56 10/28/11 dont rebuild, let it break 200,000miles and demand a retune - Dane (Houston) 16:20:22 11/02/11 What is the reason for the rebuild? - Jc (Houston) 18:01:31 11/02/11
Post a Followup	You cannot reply to this message because you are not logged in.