Subject	I have been chasing a confusing hesitation problem
Posted by	ae300z on October 26, 2011 at 10:30 PM
	This message has been viewed 167 times.
Message	The motor would start fine, idle fine, run fine, pull fine...until I hit 18+ psi. It felt like I was hitting the rev limiter. It would be worse at higher psi. The motor would pull fine if I rolled into the throttle. WOT and 18+ psi it was horrible. I changed plugs, checked for boost leaks, checked throttle, cleaned MAS, then changed MAS, changed CAS, fuel pressure is good, AFR good. Changed coil packs and bingo. #6 is on it's way out. notice the "blow out" area between the screw heads on the right coilpack compared with good coilpack on the left. Hope this helps someone in the future chasing a similiar problem.
Follow Ups	I have been chasing a confusing hesitation problem - ae300z 22:30:33 10/26/11 I remember having a Ford 390 that started missing after - JMartz 18:07:12 10/27/11
Post a Followup	You cannot reply to this message because you are not logged in.