Subject	good advice
Posted by	aliaZ on October 22, 2011 at 11:55 AM
	This message has been viewed 93 times.
In Reply To	Measure everything, no matter who tells you it's right. posted by zellamay on October 22, 2011 at 02:09 AM
Message	Far too many people get their parts back from the machine shop and assume everything was done right. Quite often the machine shop made mistakes and is counting on the customer not double checking their work.
Follow Ups	Wrist pin install - robomatic12 19:46:03 10/20/11 Try the heating again.. - KongZTT GT28RS MD 20:05:01 10/20/11 measure your old pin and compare to your new pin - aliaZ 21:30:04 10/20/11 Re: measure your old pin and compare to your new pin - robomatic12 22:43:02 10/20/11 not sure yet - aliaZ 07:50:49 10/21/11 Do you have a way to measure the pin and bore? - BlackholeZ 02:19:50 10/21/11 Re: Do you have a way to measure the pin and bore? - robomatic12 10:54:07 10/21/11 There is no such thing as a vernier caliper - zellamay 02:15:53 10/22/11 Measure everything, no matter who tells you it's right. - zellamay 02:09:34 10/22/11 Re: Measure everything, no matter who tells you it's right. - robomatic12 09:24:55 10/22/11 good advice - aliaZ 11:55:10 10/22/11
Post a Followup	You cannot reply to this message because you are not logged in.