Subject	There is no such thing as a vernier caliper
Posted by	zellamay on October 22, 2011 at 2:15 AM
	This message has been viewed 103 times.
In Reply To	Re: Do you have a way to measure the pin and bore? posted by robomatic12 on October 21, 2011 at 10:54 AM
Message	accurate to .0001". Dial bore or inside mics, and the skill to use them, are needed. (The old machine shop slang for verniers is "very nears", and very near is not good enough.)
Follow Ups	Wrist pin install - robomatic12 19:46:03 10/20/11 Try the heating again.. - KongZTT GT28RS MD 20:05:01 10/20/11 measure your old pin and compare to your new pin - aliaZ 21:30:04 10/20/11 Re: measure your old pin and compare to your new pin - robomatic12 22:43:02 10/20/11 not sure yet - aliaZ 07:50:49 10/21/11 Do you have a way to measure the pin and bore? - BlackholeZ 02:19:50 10/21/11 Re: Do you have a way to measure the pin and bore? - robomatic12 10:54:07 10/21/11 There is no such thing as a vernier caliper - zellamay 02:15:53 10/22/11 Measure everything, no matter who tells you it's right. - zellamay 02:09:34 10/22/11 Re: Measure everything, no matter who tells you it's right. - robomatic12 09:24:55 10/22/11 good advice - aliaZ 11:55:10 10/22/11
Post a Followup	You cannot reply to this message because you are not logged in.