Subject	Measure everything, no matter who tells you it's right.
Posted by	zellamay on October 22, 2011 at 2:09 AM
	This message has been viewed 106 times.
In Reply To	Wrist pin install posted by robomatic12 on October 20, 2011 at 07:46 PM
Message	This is possibly rule #1 in replacing any part. Measure it even if it comes from the most reliable source in the world. If you don't have the proper measuring tools, buy them, take the parts to someone who does, or just don't do the job. You could, by luck, get some parts together that are not right, and not know it until the engine failed again. Measure everything.
Follow Ups	Wrist pin install - robomatic12 19:46:03 10/20/11 Try the heating again.. - KongZTT GT28RS MD 20:05:01 10/20/11 measure your old pin and compare to your new pin - aliaZ 21:30:04 10/20/11 Re: measure your old pin and compare to your new pin - robomatic12 22:43:02 10/20/11 not sure yet - aliaZ 07:50:49 10/21/11 Do you have a way to measure the pin and bore? - BlackholeZ 02:19:50 10/21/11 Re: Do you have a way to measure the pin and bore? - robomatic12 10:54:07 10/21/11 There is no such thing as a vernier caliper - zellamay 02:15:53 10/22/11 Measure everything, no matter who tells you it's right. - zellamay 02:09:34 10/22/11 Re: Measure everything, no matter who tells you it's right. - robomatic12 09:24:55 10/22/11 good advice - aliaZ 11:55:10 10/22/11
Post a Followup	You cannot reply to this message because you are not logged in.