Subject	Re: Do you have a way to measure the pin and bore?
Posted by	robomatic12 on October 21, 2011 at 10:54 AM
	This message has been viewed 102 times.
In Reply To	Do you have a way to measure the pin and bore? posted by BlackholeZ on October 21, 2011 at 02:19 AM
Message	Yeah I do not have a dial bore gauge but I have a vernier caliper accurate to 0.0001". I have to grab the new piston/pin back from the machine shop but with the old piston last night I heated it in my oven and the pin slipped in and out. With that piston at room temp there was a 0.0005 interfearance fit but once it was at 150*f I measured again it was 0" fit. Does that sound about right or should I have the machine shop measure more accurately?
Follow Ups	Wrist pin install - robomatic12 19:46:03 10/20/11 Try the heating again.. - KongZTT GT28RS MD 20:05:01 10/20/11 measure your old pin and compare to your new pin - aliaZ 21:30:04 10/20/11 Re: measure your old pin and compare to your new pin - robomatic12 22:43:02 10/20/11 not sure yet - aliaZ 07:50:49 10/21/11 Do you have a way to measure the pin and bore? - BlackholeZ 02:19:50 10/21/11 Re: Do you have a way to measure the pin and bore? - robomatic12 10:54:07 10/21/11 There is no such thing as a vernier caliper - zellamay 02:15:53 10/22/11 Measure everything, no matter who tells you it's right. - zellamay 02:09:34 10/22/11 Re: Measure everything, no matter who tells you it's right. - robomatic12 09:24:55 10/22/11 good advice - aliaZ 11:55:10 10/22/11
Post a Followup	You cannot reply to this message because you are not logged in.