Subject	Do you have a way to measure the pin and bore?
Posted by	BlackholeZ on October 21, 2011 at 2:19 AM
	This message has been viewed 96 times.
In Reply To	Wrist pin install posted by robomatic12 on October 20, 2011 at 07:46 PM
Message	If you've got much of an interference fit that could be bad, and forcing it by heating/freezing will only cause problems once you get it installed. The FSM calls out 0-.0002" clearance and should be able to be installed by hand at room temperature. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Wrist pin install - robomatic12 19:46:03 10/20/11 Try the heating again.. - KongZTT GT28RS MD 20:05:01 10/20/11 measure your old pin and compare to your new pin - aliaZ 21:30:04 10/20/11 Re: measure your old pin and compare to your new pin - robomatic12 22:43:02 10/20/11 not sure yet - aliaZ 07:50:49 10/21/11 Do you have a way to measure the pin and bore? - BlackholeZ 02:19:50 10/21/11 Re: Do you have a way to measure the pin and bore? - robomatic12 10:54:07 10/21/11 There is no such thing as a vernier caliper - zellamay 02:15:53 10/22/11 Measure everything, no matter who tells you it's right. - zellamay 02:09:34 10/22/11 Re: Measure everything, no matter who tells you it's right. - robomatic12 09:24:55 10/22/11 good advice - aliaZ 11:55:10 10/22/11
Post a Followup	You cannot reply to this message because you are not logged in.