Subject	measure your old pin and compare to your new pin
Posted by	aliaZ on October 20, 2011 at 9:30 PM
	This message has been viewed 93 times.
In Reply To	Wrist pin install posted by robomatic12 on October 20, 2011 at 07:46 PM
Message	I just did this the other day...put a set of pistons in the oven for a bit, and the pins came right out
Follow Ups	Wrist pin install - robomatic12 19:46:03 10/20/11 Try the heating again.. - KongZTT GT28RS MD 20:05:01 10/20/11 measure your old pin and compare to your new pin - aliaZ 21:30:04 10/20/11 Re: measure your old pin and compare to your new pin - robomatic12 22:43:02 10/20/11 not sure yet - aliaZ 07:50:49 10/21/11 Do you have a way to measure the pin and bore? - BlackholeZ 02:19:50 10/21/11 Re: Do you have a way to measure the pin and bore? - robomatic12 10:54:07 10/21/11 There is no such thing as a vernier caliper - zellamay 02:15:53 10/22/11 Measure everything, no matter who tells you it's right. - zellamay 02:09:34 10/22/11 Re: Measure everything, no matter who tells you it's right. - robomatic12 09:24:55 10/22/11 good advice - aliaZ 11:55:10 10/22/11
Post a Followup	You cannot reply to this message because you are not logged in.