| Message |
Hi I have a 2+2 that I TT converted back in may. A few days after I completed the swap, I went outside to start the Z (it was a little colder out) it fired up and then the RPM's fell to 0 and the car died. I tried to start it up after that and my motor would crank away but wouldn't start. I checked fuel, spark, for vacuum leaks and everything checked out. after being stumped for a few days I walked outside mid day (AZ) it was over 100 out and out of pure boredom I tried to start the Z and she fired right up. I drove around a bit then parked it, tried to start it up the next morning and NOTHING... I ended up replacing the FPR and FD and after that the car started up just fine and ran fine. No problems since.... until today. The EXACT same thing happened this morning. So far I have checked for spark, checked for fuel, swapped my fuel pump with a known good fuel pump, swapped FPR with a known good FPR (even though mine is factory brand new) I have NGK plugs, all brand new (installed during motor swap). Any Idea's where to go now?
|
 |
16:31:42 10/11/11
