Subject	Initial Steering Rack Alignment - Ground Zero
Posted by	evan_aggie(ATX) on October 10, 2011 at 4:23 PM
	This message has been viewed 340 times.
Message	I rebuilt my rack, and have no tie rods connected. Like an idiot, I through away the numbers I had recorder which were to help align me when I connected everything back. The U-joint is not connected to the rack atm. Can I simply measure the rod coming out of each end of the steering rack until they are equal, and then just connect the U-joint up to the rack, assuming of course the steering wheel is straight. I'm hopeful any small adjustments after that can be taken care of by rotating the tie rod a turn or two to move it in/out by a 1-2mm.
Follow Ups	Initial Steering Rack Alignment - Ground Zero - evan_aggie(ATX) 16:23:25 10/10/11 I think I'd put the rack in the middle of it's travel, - zellamay 01:36:22 10/11/11 be careful - aliaZ 07:53:00 10/11/11
Post a Followup	You cannot reply to this message because you are not logged in.