Subject	Help with 350Z clutch fork & pivot ball install, please >>
Posted by	my91z on October 08, 2011 at 3:51 PM
	This message has been viewed 1743 times.
Message	First off, I think this should have come with a washer to go under the pivot ball, but it didn't. Can I use the original one from my 300ZX pivot ball? If not, what thickness washer do I need so I can find one/make the correct stackup height of smaller washers? I'd like to be able to get this installed this weekend, so would rather not wait for one to be shipped to me. Pic of new ball with no washer and my chromoly 300ZX ball with washer: Second, which way does the pivot ball retainer spring go into the fork, or does it not matter? U-shaped portion up: Or U-shaped portion down: Thanks, Mike --------------------------------------------------------
Follow Ups	Help with 350Z clutch fork & pivot ball install, please >> - my91z 15:51:57 10/08/11 Yes it needs the washer and the first pic is the way it - Piranha 20:48:59 10/08/11 Thanks, is the washer the same as the OEM Z32 washer? (n/m) - my91z 20:53:25 10/08/11 Not sure... they are probably close. (n/m) - Piranha 20:56:14 10/08/11 Does anyone have a non-installed kit and could measure the > - my91z 08:49:10 10/09/11
Post a Followup	You cannot reply to this message because you are not logged in.