Subject	I had a few stuborn ones but they eventually came out
Posted by	Xteam300TT (South Tx ) on October 04, 2011 at 6:54 PM
	This message has been viewed 95 times.
In Reply To	Yeah, so I am doing it right - I'm using my bench-vise Anvil posted by Zinn2win on October 04, 2011 at 06:01 PM
Message	try soaking then in parts cleaner overnight they get varnish built on them that will come off with a good soaking . Id give that a try then start smacking again . good luck It is important to smack the lifter evenly !
Follow Ups	Disassembling Lifer Body from the Housing - Having Issues - Zinn2win 12:44:54 10/04/11 dont know how youre doing it or if this will help but - Xteam300TT (South Tx ) 16:00:11 10/04/11 Yeah, so I am doing it right - I'm using my bench-vise Anvil - Zinn2win 18:01:41 10/04/11 I had a few stuborn ones but they eventually came out - Xteam300TT (South Tx ) 18:54:26 10/04/11 Figured out the issue. These aren't 'normal' OEM Lifters... - Zinn2win 10:23:44 10/05/11 Yeah I ran into the same ??"lifters" issue... - Devin300zx 16:09:15 10/06/11
Post a Followup	You cannot reply to this message because you are not logged in.