Subject	ANOTHER UPDATE... fixed a break in inejctor harness
Posted by	Red Hawk (CO) on October 04, 2011 at 3:44 PM
	This message has been viewed 112 times.
In Reply To	can't hold 2000rpm ( stumbles ) posted by Red Hawk (CO) on October 02, 2011 at 11:01 PM
Message	I think that fixed the weird issue I had last night, becuae i've haven't the car to do it since. Still leaning out when I get on the throttle. What about clogged injector screens? is IPW (Injector pulse width) of 10.8 acceptable under full load for 270cc injectors? is there any other way to tell they could be clogged? TT BEAST IN PROGRESS!
Follow Ups	can't hold 2000rpm ( stumbles ) - Red Hawk (CO) 23:01:43 10/02/11 MAF and TPS voltages. Check for major boost leaks. (n/m) - Draker (Eugene, OR) 00:07:40 10/03/11 can find or hear any leaks. im using a selin with two mafs - Red Hawk (CO) 01:07:00 10/03/11 I would go with a single MAF to test. - Draker (Eugene, OR) 01:49:31 10/03/11 Nope. All tested good. Must be something else... (n/m) - Red Hawk (CO) 16:24:07 10/03/11 ONE NOTE... Fixed leak causing stumble, STILL LEAN! when - Red Hawk (CO) 16:27:33 10/03/11 Check fuel pressure. FPR would be the next thing i looked at - madscientist222 18:45:40 10/03/11 Fuel Pressure is base 43 and full throttle 55. due to an - Red Hawk (CO) 20:15:37 10/03/11 Have you observed your voltages for TPS and MAF under - madscientist222 11:41:43 10/04/11 TPS set to.44 and it climbs under throttle. Both it and the - Red Hawk (CO) 20:50:54 10/04/11 What do you have the Selin *set* to? (n/m) - CoHPhasor 19:54:32 10/03/11 Idk what its called, but its right. car worked fine with it - Red Hawk (CO) 20:16:43 10/03/11 UPDATE... and I think this is a weird one. - Red Hawk (CO) 23:21:17 10/03/11 Have you changed injectors or pulled the fuel rail - ztunerz 10:18:44 10/04/11 Yes I have changed an Injector, and pulled the fuel rail (n/m) - Red Hawk (CO) 12:17:33 10/04/11 You have Nistune correct? - Woody75 (Denver) 08:14:06 10/04/11 Still basic setup, only using nistune for the diagnostics - Red Hawk (CO) 12:20:12 10/04/11 ANOTHER UPDATE... fixed a break in inejctor harness - Red Hawk (CO) 15:44:17 10/04/11 You need to stop fishing and get thorough. - CoHPhasor 19:25:40 10/04/11 Before you jump to conclusions, I did do a power balance... - Red Hawk (CO) 20:46:24 10/04/11 Ok, I'll give you that I could be jumping to conclusions... - CoHPhasor 21:48:13 10/04/11 Yes. Im sorry, Im jumping to conclusions now, I figured - Red Hawk (CO) 21:59:01 10/04/11
Post a Followup	You cannot reply to this message because you are not logged in.