Subject	I have selin elbows but use a apexi neo to average the
Posted by	Wright (Ca) on October 03, 2011 at 9:52 PM
	This message has been viewed 266 times.
In Reply To	Re: Wandering AFR at idle and hesitation under WOT. posted by sandmanz32 on October 03, 2011 at 09:12 PM
Message	two signals(dual pop program). The car has ran flawless since having it dyno tuned at specialty z and I have not messed with anything since then with the exception of the gears and speed sensor. I dont believe they are the cause but did notice the issues began about the same time. "...You can't take it with you, live life to it's fullest, love your kids and your wife and the simple things in life....smile and laugh as often as you can!" sawbonez September 11, 2011 at 6:11 PM Formerly: ZEVAN (Ca), Evan3zx(ca)
Follow Ups	Wandering AFR at idle and hesitation under WOT. - Wright (Ca) 20:50:41 10/03/11 check the MAFS signal voltage (n/m) - sandmanz32 21:09:45 10/03/11 Re: Wandering AFR at idle and hesitation under WOT. - sandmanz32 21:12:56 10/03/11 I have selin elbows but use a apexi neo to average the - Wright (Ca) 21:52:00 10/03/11 Cloosed loop or open at idle? (n/m) - Wright (Ca) 08:25:40 10/04/11 open loop at idle (n/m) - sandmanz32 18:27:39 10/04/11 So I left the fuel pressure gauge hooked up over - Wright (Ca) 09:05:19 10/04/11 Are you using a stock or aftermarket regulator? (n/m) - Woody75 (Denver) 09:01:19 10/05/11 Stock. I installed new reg/dampener/filter a few thousand - Wright (Ca) 10:55:54 10/05/11 Re: Wandering AFR at idle and hesitation under WOT. - WazTTed 15:58:32 10/04/11 Thanks. I did this test years ago and thought I remembered - Wright (Ca) 16:07:34 10/04/11 yea, i second that. get your fuel leak buttoned down - sandmanz32 17:49:21 10/04/11 My fuel pressure drops but it doesn't affect idle. Based - treese88 11:12:36 10/05/11 What do you use to clamp the line off with? Seems - Wright (Ca) 11:48:18 10/05/11 Vice grips with quarters on the clamping part to create a - treese88 09:06:04 10/06/11
Post a Followup	You cannot reply to this message because you are not logged in.