Subject	I'm going to go out on a limb here and say no, because
Posted by	zellamay on October 03, 2011 at 6:12 PM
	This message has been viewed 141 times.
In Reply To	Any way to verify individual turbo integrity? posted by blackomega on October 03, 2011 at 04:47 PM
Message	there's not a way to isolate the output of either turbo. The DS turbo feeds the PS cylinders, which spool the PS turbo, which feeds the DS cylinders, which spool the DS turbo ....... and so on.
Follow Ups	Any way to verify individual turbo integrity? - blackomega 16:47:45 10/03/11 Pull the downpipe and physically check both of them. - Draker (Eugene, OR) 17:58:14 10/03/11 I swapped downpipes about 500 miles ago or so - blackomega 18:18:49 10/03/11 Are you having an issue with boosting, or smoke? - sandmanz32 18:36:01 10/03/11 I had some blunt force trauma to the PS Testpipe/DP setup - blackomega 19:41:28 10/03/11 Re: I had some blunt force trauma to the PS Testpipe/DP setup - sandmanz32 20:40:58 10/03/11 Tell us about the BFT... What happened? (n/m) - thumper 22:58:44 10/03/11 ran over a parking stop with my front right wheel - blackomega 10:42:19 10/04/11 I'm going to go out on a limb here and say no, because - zellamay 18:12:24 10/03/11 Re: I'm going to go out on a limb here and say no, because - blackomega 18:20:15 10/03/11 I think so, since they feed each other, in effect. - zellamay 18:34:55 10/03/11 I always thought you could put boost gauges in the locations - blackomega 19:56:39 10/03/11 Re: I always thought you could put boost gauges in the locations - 94ttz32 05:55:33 10/07/11
Post a Followup	You cannot reply to this message because you are not logged in.