Subject	new suspension. binding issue.
Posted by	EpiDeMiCc on October 03, 2011 at 3:44 PM
	This message has been viewed 100 times.
Message	Hey everyone, so i am having an issue trying to swap coilovers from one z to the other. one has a kyb/tien setup, the other are ksport coilovers. my issue is that when i get the two assemblies off and go to switch them i cant get the kyb setup to connect with the knuckle on the car that used to have the ksports. i am prying it down as much as i can but the setup just doesnt travel that far. the connection for the knuckle sits about 4-5 inches higher than the hole on the strut. my theory is that the car has been aligned for the lower suspension and the tie rods aren't allowing the knuckles to drop lower, but i dont want to do an alignment before and after i swap suspensions if i am wrong about this. can anyone elaborate on this for me?
Follow Ups	new suspension. binding issue. - EpiDeMiCc 15:44:40 10/03/11 Are you talking about front or rear? (n/m) - KongZTT GT28RS MD 17:56:00 10/03/11 If you have them close to each other then why not - CoHPhasor 19:52:17 10/03/11 Re: If you have them close to each other then why not - EpiDeMiCc 14:28:46 10/04/11 Disconnect the sway bar end links? (n/m) - zgene4 16:34:21 10/04/11
Post a Followup	You cannot reply to this message because you are not logged in.