Subject	Re: Need help with - AVCR set up with external wastegates plumbi
Posted by	Stadsport (PHX) on September 29, 2011 at 12:57 PM
	This message has been viewed 397 times.
In Reply To	Need help with - AVCR set up with external wastegates plumbi posted by 2ZXTRM on September 29, 2011 at 12:46 PM
Message	If you're using external wastegates, you need to use the NC port, not the NO port. The setups should otherwise be pretty much identical: The differences being that the green line should run from the "to throttle body" pipe to the NC port instead of the NO port, and of course the wastegates are external and not actuator types. The setup described in the AVC-R manual is accurate. If you're having trouble boosting past 16psi, but can otherwise control the boost, I would look elsewhere for reasons (wastegate spring pressure, boost leaks, etc).
Follow Ups	Need help with - AVCR set up with external wastegates plumbi - 2ZXTRM 12:46:03 09/29/11 Re: Need help with - AVCR set up with external wastegates plumbi - Stadsport (PHX) 12:57:07 09/29/11 So - Option 2 connected to - 2ZXTRM 13:11:51 09/29/11 Also, don't forget to remove the plug from the unused port - Wright (Ca) 17:42:39 09/29/11 more info inside - if others can offer more opinions - 2ZXTRM 21:53:26 09/29/11
Post a Followup	You cannot reply to this message because you are not logged in.