Subject	This is my first tech post so it wasn't me,
Posted by	Markzxj on September 28, 2011 at 2:13 AM
	This message has been viewed 115 times.
In Reply To	I think you asked this before.. posted by Draker (Eugene, OR) on September 27, 2011 at 08:30 PM
Message	If you look at the pic that Stadsport posted, the drive pin that attaches to the pulley is still attached to my cam. The small half moon that is used to align the cas and ensure that you are not off a tooth is broken off. I already have the cas on and aligned correctly so I'm not worried about that. My question is does missing that half moon alignment tab have any effect on my timing.
Follow Ups	CAS question - Markzxj 17:04:39 09/27/11 Re: CAS question - Stadsport (PHX) 18:18:04 09/27/11 Re: Re: CAS question - Markzxj 19:39:06 09/27/11 You will be fine with out the aliighment tab. - Woody75 (Denver) 10:42:11 09/28/11 Re: Re: Re: CAS question - Stadsport (PHX) 12:35:16 09/28/11 I think you asked this before.. - Draker (Eugene, OR) 20:30:14 09/27/11 This is my first tech post so it wasn't me, - Markzxj 02:13:35 09/28/11
Post a Followup	You cannot reply to this message because you are not logged in.