Subject	Preparing for pull, want to nail this problem down first.
Posted by	Red Hawk (CO) on September 24, 2011 at 3:57 PM
	This message has been viewed 167 times.
Message	still haven't figured whats wrong with my car and i want to have it nailed down before i pull the motor to start the swap disassembly. car starts rough and leans out beyond my widebands reading in about 15 seconds. all injectors ohm and click tested. spark plugs look ok, but a power balance by taking the spark plug wires off show that cylinders 2 and 5 do not seem affected when the wires are removed. this is the forth time ive played with the fuel rail, and its getting tiring. there are new oem rail to lower plenum seals and new upper/lower plenum gasket, idk if its an air leak or where to find it... im genuinely out of ideas this time. TT BEAST IN PROGRESS!
Follow Ups	Preparing for pull, want to nail this problem down first. - Red Hawk (CO) 15:57:31 09/24/11 try spraying carb cleaner around cylinders 2 and 5 - aliaZ 16:11:23 09/24/11 how do your plugs look for 2 and 5? (n/m) - aliaZ 16:17:43 09/24/11 ok, cylinder 2 had broken spark harness. injector cleaner - Red Hawk (CO) 16:37:13 09/24/11 cylinder 2 is all good now, but 5 is still dead. same side - Red Hawk (CO) 19:52:27 09/24/11
Post a Followup	You cannot reply to this message because you are not logged in.