Subject	I had the same problem after i did my swap and
Posted by	Z OLOGY on September 11, 2011 at 8:35 AM
	This message has been viewed 100 times.
In Reply To	low oil pressure!!!need your help posted by JOZ32 on September 08, 2011 at 04:09 PM
Message	even though the dent seems small, like the guys said above the clearance is very very small... I tried everything and nothing worked, until I took the pan out and knock the dent out... and not only did the oil pressure go right up, but the motor got a lot more quiet since everything was properly lubricated now. IT'S A VERY COMMON PROBLEM ON JDM SWAPS.
Follow Ups	low oil pressure!!!need your help - JOZ32 16:09:33 09/08/11 What oil are you using? - MixManMash 17:33:28 09/08/11 Re: What oil are you using? - JOZ32 02:05:05 09/09/11 i would make sure the pan isnt pushed in blocking - xteam300tt 21:35:38 09/08/11 If you used a JDM motor then check the oil pan. - JonnyZ(SoCal) 12:39:28 09/09/11 Yes I used a JDM engine,the oil pan has few dents - JOZ32 15:22:57 09/09/11 you dont have to pull the pan off . You can bend a screw - xteam300tt 18:36:08 09/09/11 I had the same problem after i did my swap and - Z OLOGY 08:35:35 09/11/11 Re: I had the same problem after i did my swap and - JOZ32 08:53:02 09/11/11
Post a Followup	You cannot reply to this message because you are not logged in.