Subject	Re: For those with '90 nose panels and JDM Emblems...
Posted by	84z90z on September 09, 2011 at 8:58 PM
	This message has been viewed 84 times.
In Reply To	For those with '90 nose panels and JDM Emblems... posted by dmv300z on September 09, 2011 at 04:17 PM
Message	Those two little tabs on the back just need to be shaved down flush. Then when you go to put the emblem one be sure to measure it and center it correctly. Use a tape measure and take your time. Z emblem ftw :) :If you have a '90 nose panel (smooth, no hamburger emblem) how did you go about affixing your JDM emblem? There are two little posts on the back of the emblem and I've seen that replacement JDM panels have two small holes that match up with the posts. :Did you drill two small holes to accommodate the posts or shave them off, or do something else entirely? :Thanks in advance for your help. src=http://img706.imageshack.us/img706/2354/siguc.jpg>
Follow Ups	For those with '90 nose panels and JDM Emblems... - dmv300z 16:17:24 09/09/11 Re: For those with '90 nose panels and JDM Emblems... - 84z90z 20:58:59 09/09/11
Post a Followup	You cannot reply to this message because you are not logged in.