Subject	you dont have to pull the pan off . You can bend a screw
Posted by	xteam300tt on September 09, 2011 at 6:36 PM
	This message has been viewed 109 times.
In Reply To	Yes I used a JDM engine,the oil pan has few dents posted by JOZ32 on September 09, 2011 at 03:22 PM
Message	driver or something solid into an "L" shape and pop the dent out from the inside by going through the oil drain plug hole . Thats what shippers of JDM engines recomend . As Jonny said " the clearance between the pan and pickup tube is very small .
Follow Ups	low oil pressure!!!need your help - JOZ32 16:09:33 09/08/11 What oil are you using? - MixManMash 17:33:28 09/08/11 Re: What oil are you using? - JOZ32 02:05:05 09/09/11 i would make sure the pan isnt pushed in blocking - xteam300tt 21:35:38 09/08/11 If you used a JDM motor then check the oil pan. - JonnyZ(SoCal) 12:39:28 09/09/11 Yes I used a JDM engine,the oil pan has few dents - JOZ32 15:22:57 09/09/11 you dont have to pull the pan off . You can bend a screw - xteam300tt 18:36:08 09/09/11 I had the same problem after i did my swap and - Z OLOGY 08:35:35 09/11/11 Re: I had the same problem after i did my swap and - JOZ32 08:53:02 09/11/11
Post a Followup	You cannot reply to this message because you are not logged in.