Subject	Get the compression figured out first.
Posted by	Draker (Eugene, OR) on September 07, 2011 at 11:18 AM
	This message has been viewed 78 times.
In Reply To	Input on compression test posted by Alter Ego Trip on September 06, 2011 at 11:24 PM
Message	I believe the tolereance is ~14psi between cylinders. Get a picture of where the cas is positioned. If it's not dead center, likely the timing is off.
Follow Ups	Input on compression test - Alter Ego Trip 23:24:31 09/06/11 Get the compression figured out first. - Draker (Eugene, OR) 11:18:54 09/07/11 I was thinking timing belt slightly off... - supermario680 19:31:03 09/07/11 Re: I was thinking timing belt slightly off... - Alter Ego Trip 22:18:41 09/08/11
Post a Followup	You cannot reply to this message because you are not logged in.