TwinTurbo.NET: Nissan 300ZX forum - Re: I assume you mean that you will be in there anyway
Subject
Re: I assume you mean that you will be in there anyway
Posted by
EpiDeMiCc
on September 02, 2011 at 10:58 PM
This message has been viewed
75
times.
In Reply To
I assume you mean that you will be in there anyway
posted by zellamay
on September 02, 2011 at 08:56 PM
Message
you think a light emory cloth sanding would be a smart idea to get any glazing off? i have been pretty good to it in 2nd, but there was a few times where i got fucked on a hill and had a nasty start. then things you do when you are desperate :/
Follow Ups
pressure plate/flywheel questions for a clutch job.
-
EpiDeMiCc
20:28:28 09/02/11
I assume you mean that you will be in there anyway
-
zellamay
20:56:15 09/02/11
Re: I assume you mean that you will be in there anyway -
EpiDeMiCc
22:58:47 09/02/11
Again, can't give an opinion without inspecting it.
-
zellamay
09:36:00 09/03/11
Re: pressure plate/flywheel questions for a clutch job.
-
dub-ya
00:32:46 09/04/11
flywheel & pressure plates?
-
EpiDeMiCc
22:46:20 09/04/11
Post a
Followup
You cannot reply to this message because you are not
logged in
.