Subject	I assume you mean that you will be in there anyway
Posted by	zellamay on September 02, 2011 at 8:56 PM
	This message has been viewed 83 times.
In Reply To	pressure plate/flywheel questions for a clutch job. posted by EpiDeMiCc on September 02, 2011 at 08:28 PM
Message	to repair/replace the tranny. I'd inspect it before deciding to replace. It could be okay, depends on how good you have been in 2nd gear starts, and how many you've done in 10k. But if it's worn down too much that soon, it's seen a lot of heat. I'd do a full clutch job: PP, lighweight flywheel, etc.
Follow Ups	pressure plate/flywheel questions for a clutch job. - EpiDeMiCc 20:28:28 09/02/11 I assume you mean that you will be in there anyway - zellamay 20:56:15 09/02/11 Re: I assume you mean that you will be in there anyway - EpiDeMiCc 22:58:47 09/02/11 Again, can't give an opinion without inspecting it. - zellamay 09:36:00 09/03/11 Re: pressure plate/flywheel questions for a clutch job. - dub-ya 00:32:46 09/04/11 flywheel & pressure plates? - EpiDeMiCc 22:46:20 09/04/11
Post a Followup	You cannot reply to this message because you are not logged in.