Subject	Not really..
Posted by	Stadsport (PHX) on September 01, 2011 at 3:12 PM
	This message has been viewed 80 times.
In Reply To	2 terms for the same thing posted by sandmanz32 on September 01, 2011 at 10:32 AM
Message	They're somewhat related, but aren't the same thing. Latency refers to how long it takes for the injector to open (or close); it's the delay between when the power is sent and when it's actually open. Pulsewidth is how long the injector is open, not how long it takes to open. The latency is factored into the pulsewidth, but they're separate parameters and aren't interchangeable.
Follow Ups	Injector Latency for 555s - Stadsport (PHX) 18:39:51 08/31/11 Niether is "better" - sandmanz32 20:13:32 08/31/11 Latency... not pulsewidth... (n/m) - Stadsport (PHX) 21:01:29 08/31/11 2 terms for the same thing - sandmanz32 10:32:37 09/01/11 Not really.. - Stadsport (PHX) 15:12:02 09/01/11 Interesting - sandmanz32 18:50:39 09/02/11 Re: Interesting - Stadsport (PHX) 21:32:41 09/02/11 Latency mainly effects idle and I believe .77ms is about - treese88 12:01:17 09/01/11 correct (n/m) - The Devils Z 14:35:09 09/01/11 Re: Latency mainly effects idle and I believe .77ms is about - Stadsport (PHX) 15:14:06 09/01/11 By the way... - Stadsport (PHX) 15:18:59 09/01/11 I believe 740s are still closer to .77ms. A rich idle - treese88 09:43:33 09/02/11 I'll stick to .77ms then - Stadsport (PHX) 21:35:17 09/02/11
Post a Followup	You cannot reply to this message because you are not logged in.