Subject	Re: Pin 36
Posted by	TRdave on August 29, 2011 at 4:52 PM
	This message has been viewed 103 times.
In Reply To	Pin 36 posted by Draker (Eugene, OR) on August 29, 2011 at 01:24 PM
Message	The connector to the sensor was questionable so i tightened it up. I tested the resistance of the sensor and i got 2.3 when cool. That should be good. I also made sure the wire back to the ecu was not broken and it is good. Now I just wait for the CAS to arrive right? Or do i need to push some new fuel through the rail or anything like that? :[ http://www.twinturbo.net/nissan/300zx/forums/main/view/1104179/Yet-another-ECU-connector-pin-out.html ] :Unplug the sensor, unplug the ECU harness. Using a meter check for continuity from the harness to pin 36.
Follow Ups	Up and running then stalled again. - TRdave 09:20:11 08/29/11 You either didn't plug it in.. - Draker (Eugene, OR) 12:00:44 08/29/11 Re: You either didn't plug it in.. - TRdave 12:48:33 08/29/11 Pin 36 - Draker (Eugene, OR) 13:24:56 08/29/11 Re: Pin 36 - TRdave 16:52:49 08/29/11 Nope, just wait for the CAS. - Draker (Eugene, OR) 10:17:55 08/30/11
Post a Followup	You cannot reply to this message because you are not logged in.